Set up OctoPrint on a Raspberry Pi - LIVE via Starlink!
Jeff Geerling 46:43
22,412 views · 388 likes Watch on YouTube ↗
During this live stream, I'll attempt to get OctoPrint set up on a Raspberry Pi 4 so I can have more control over my Ender 3 V2 printer. I'll also be streaming directly over Starlink, through SpaceX's satellite constellation using Dishy on my roof!
Will the stream work? Will my 3D Printer start printing spaghetti? Who knows! Find out LIVE during this stream.
Products used in this stream (links are affiliate links):
- Ender 3 V2: https://amzn.to/3de6Yy4
- Ender 3 Fireproof 3D Printer Enclosure: https://amzn.to/32aLNHc
- Gulfcoast Robotics Ender 3 LED Light: https://amzn.to/32agnRe
- Raspberry Pi 4 model B: https://amzn.to/3dcFXet
- Argon One M.2 case: https://amzn.to/3sf4ZxX
- Kingston A400 120 GB SATA SSD: https://amzn.to/3se3hwE
Support me on Patreon: https://www.patreon.com/geerlingguy
Sponsor me on GitHub: https://github.com/sponsors/geerlingguy
#RaspberryPi #OctoPrint #Starlink
Contents:
Will be posted after livestream ends.
Will the stream work? Will my 3D Printer start printing spaghetti? Who knows! Find out LIVE during this stream.
Products used in this stream (links are affiliate links):
- Ender 3 V2: https://amzn.to/3de6Yy4
- Ender 3 Fireproof 3D Printer Enclosure: https://amzn.to/32aLNHc
- Gulfcoast Robotics Ender 3 LED Light: https://amzn.to/32agnRe
- Raspberry Pi 4 model B: https://amzn.to/3dcFXet
- Argon One M.2 case: https://amzn.to/3sf4ZxX
- Kingston A400 120 GB SATA SSD: https://amzn.to/3se3hwE
Support me on Patreon: https://www.patreon.com/geerlingguy
Sponsor me on GitHub: https://github.com/sponsors/geerlingguy
#RaspberryPi #OctoPrint #Starlink
Contents:
Will be posted after livestream ends.
Category (YouTube): Science & Technology
Playback is via YouTube's official embedded player. Data from YouTube; Exumo is not affiliated with YouTube.