How to Make a Compact Animatronic Eye Mechanism with 3D Printing and Arduino

This project is an upgraded version of my previous design, a highly compact and robust animatronic eye mechanism which uses 3D printed components and an Arduino microcontroller. If you are able to get hold of servo ball-links and pushrods, and are reasonably competent with 3D printing, this is the eye mechanism project I'd recommend most!

Support me on Patreon for access to all my CAD files! http://patreon.com/Will_Cogley

My Setup/Recommendations:
🖨️ My Workhorse 3D Printer: https://shareasale.com/r.cfm?b=2377904&u=4178914&m=138211&urllink=&afftrack=
🖨️ Fancy Colour-Changing 3D Printer: https://shareasale.com/r.cfm?b=2354728&u=4178914&m=138211&urllink=&afftrack=
🔧 Screwdrivers: https://amzn.to/3WFHXDp
🔌 Power Supply: https://amzn.to/3UYY6lP
🔥 Soldering Station: https://amzn.to/3wAYj5u

All Projects: https://willcogley.notion.site/
Patreon: http://patreon.com/Will_Cogley
Discord Server: https://discord.gg/qXKNRgHKNB
Contact: enquiries@willcogley.com
Also check the instructable for comprehensive detailed text instructions: https://www.instructables.com/id/DIY-Compact-3D-Printed-Animatronic-Eye-Mechanism/

- Screws: https://amzn.to/3Vmtrjg (this kit should cover you)
- Around *40** *M2 x 6mm* screws
- *6* 10mm M2* screws
- 6* MG90s servo screws (these come with the servos: https://amzn.to/33VfIlF)
- Hobby Components
- *4* M2* Servo Ball-links: https://amzn.to/3TEbz1R
- *4* M2 x 25mm* Pushrod Connectors: https://amzn.to/3Pl44uc (keep in mind this is just *2mm* threaded bar - you could always cut down a *25mm* bolt or some plain threaded rod)
- Electronics
- Arduino Uno: https://amzn.to/3VfGbYR (or anything that can accept three analogue signals, one digital and communicate through SDA/SCL ports)Adafruit PCA9685
- 16-Channel Servo Driver: https://amzn.to/4cijGsg
- 5V Power Supply, around 4A is more than enough: https://amzn.to/49Wqni0
- A female DC power jack to match your power supply, to be soldered to the servo driver board: https://amzn.to/43j0KFC
- *2* axis Joystick: https://amzn.to/2NR4JnY
- Potentiometer (optional): https://amzn.to/2r0nADS
- Push-to-make switch (Some joysticks have this built in, but its easier to control when it’s separate: https://amzn.to/32Wnvyh )
- 10k Resistor: https://amzn.to/374seRU
- Jumper cables: https://amzn.to/2NToCuw
- *6** MG90s servos: https://amzn.to/4afx4vv

Also, a pin vice hand drill might be useful for adjusting hole sizes: https://amzn.to/4afx7rb

Contact: enquiries@willcogley.com
Discord Server: https://discord.gg/df57eVP